Open-Type Full Automatic Inner-Barrel Pipe Pole Ribbing Machine

It is applicable for two reinforcing fillets being formed on the both sides of vacuum tube hole in the water barrel Open-Type Full Automatic Inner-Barrel Pipe Pole Ribbing Machine  Product introduction It is applicable for two reinforcing fillets being formed on the both sides of vacuum tube hole in the water barrel of solar water heater and keeping these vacuum tube holes of inner-barrel in the same horizontal line so as to enforce them by two to three degree against tube hole variation during the operation or pressing trace about the break. It is advanced in the many aspects, such as no special mould being usage, lower usage cost, easy installation and operation and high flatness.

Product features

1. This equipment is made by welding steel plate and other steel.

2. The device adopts compressed air through the cylinder up and down as pressure power.

3. The equipment adopts simple lock device through the cylinder up and down. Cylinder is tightly fasten to work position during working, and to loosen locking device of end work. After finishing those things, it can draw out workpiece.

4. The front of cylinder puts into device and moves to the localization slot during working, then you can press the top and bottom key of cylinder to pressuring cylinder and the muscle guide tightly. Then, starting motor power moves pressure roll to achieve the purpose of molding.

Technical specification

Model specification	Rated voltage	The power rating	Compressed air
L1500/L2000/L2500/L3000/L3200mm	380V	1.5KVA	0.45Mpa

Open-Type Full Automatic Inner-Barrel Pipe Pole Ribbing Machine